Battery Removal/Installation - Berner BACIS 14,4V LI Instrucciones De Servicio

English
10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove
it from the equipment or battery charger, and stop
use.
CAUTION
1. If liquid leaking from the battery gets into your eyes,
do not rub your eyes and wash them well with fresh
clean water such as tap water and contact a doctor
immediately.
I f l e f t u n t r e a t e d , t h e l i q u i d m a y c a u s e
eye-problems.
2. If liquid leaks onto your skin or clothes, wash well
with clean water such as tap water immediately.
There is a possibility that this can cause skin
irritation.
SPECIFICATIONS
POWER TOOL
Model
Power mode
No-load speed
Save mode
Small screw
Capacity Ordinary bolt
High tension bolt
Tightening torque
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to remove
the battery (see Figs. 1 and 2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
21
3.
WARNING
If an electrically conductive foreign object enters the terminals
of the lithium ion battery, a short-circuit may occur resulting
in the risk of fire. Please observe the following matters when
storing the battery.
○
○
Power mode
Maximum 145 N·m (1480 kgf·cm)
Save mode
Maximum 80 N·m (820 kgf·cm)
Tightening is M14 high tension bolt (strength grade 12.9), when fully charged at
20°C temp.
Tightening time: 3 sec.
CHARGING
BCAC-LI
Before using the power tool, charge the battery as follows.
14.4 V 18 V
1. Connect the charger's power cord to a receptacle.
0.6 kg
2. Insert the battery into the charger.
3. Charging
(1) Pilot lamp indication
If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using
the battery for the first time, do not use and return
it to your supplier or vendor.
Do not place electrically conductive cuttings,
nails, steel wire, copper wire or other wire in
the storage case.
Either install the battery in the power tool or
store by securely pressing into the battery
cover until the ventilation holes are concealed
to prevent short-circuits (See Fig. 1).
BACIS 14.4 V LI
0 – 2600 min
–1
0 – 2000 min
–1
M4 – M8
M5 – M14
M5 – M12
BAC-LI (14.4 V 3.0 Ah 8 cells)
1.4 kg
When the power cord is connected, the charger's pilot
lamp will blink in red. (At 1-second intervals)
Firmly insert the battery into the charger until the line is
visible, as shown in Fig. 3, 4.
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.