Use; System Start-Up; Filling The Water Heater - Thermor AEROMAX ACCESS Serie Manual

Presentation

1. System start-up

1.1. Filling the water heater

❶ Open the hot water tap(s).
❷ Open the cold water tap on the safety unit (ensure that the safety unit drain valve is closed).
❸ Close the hot water valves after draining them. The water heater has been filled with water.
❹ Check the sealing of the pipe socket connections.
❺ Check the operation of the hydraulic components, by repeatedly opening the safety unit drain valve to
eliminate any residue in the discharge valve.
1.2. Control interface
If the water heater has been tilted, wait at least 1 hour before start-up
Pairing button
Absence mode
(anti-freezing)
PLEASE NOTE: If the appliance is inactive for 60 seconds, the interface goes into standby mode and the
Water Drop light goes out.
The circle of the mode selected flashes every 10 seconds. The bar under the Wi-Fi symbol flashes at the
same time every 10 seconds if the appliance is connected.
It is possible to switch off the interface by simultaneously pressing on the ECO+ and Absence buttons for
3 seconds.
The display can be temporarily reactivated simply by pressing any button. Then it is deactivated again.
The appliance continues to operate.
Deep sleep mode can be deactivated by the same combination of buttons.
Installation
Manual Mode

Use

Maintenance
Use
Warranty
Available hot water and
heating indicators
(Water Drop)
ECO+ mode
EN
53