Thermor AEROMAX ACCESS Serie Manual página 37

CAUTION: Heavy items – handle with care:
• Install the appliance in a room protected from frost. If the
appliance is damaged because the safety device has been
tampered with, it is not covered by the warranty.
• If the appliance is to be installed in a room or location where
the ambient temperature is constantly above 35 °C, ensure that
the room is correctly ventilated.
• Position the appliance where it can be accessed.
•
When installed
bathroom, do not install the
appliance in volumes V0, V1
or V2 (see figure opposite).
If there is not enough space,
they can be installed in
volume V2.
• Refer to the installation figures. The clearance required to install
the appliance correctly is specified in the "Installation" tab.
• This product is intended for use at a maximum altitude of 2000 m.
• Do not block, cover or obstruct the air inlets and outlets of the
product.
• If the appliance is set up in a suspended ceiling or attic, or
above living space, a drain pan must be installed underneath
the water heater. A drainage device connected to the sewer
system is required.
• The water heater must (in accordance with article 20 of EN
60335-1) be fixed to the ground using a mounting system
intended for this purpose.
• This water heater is fitted with a thermostat with an operating
temperature of more than 60 °C at its maximum position,
capable of reducing the growth of legionella bacteria in the
tank. Caution! Above 50 °C, water could cause immediate
burns. Check the water temperature before taking a bath or
shower.
INSTALLATION
in a
V1
V2
V0
V0 = Volume 0
V1 = Volume 1
V2 = Volume 2
EN
35