Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Model TRP 400E
3
2
6
Image for illustration purposes only
1. Stand
2. Body and cutting disc
3. Feeding funnel
4. Motor
5. Belt guard
6. Rubber pad
Electric
TRAPP shredders, single or three phase, are fitted
with single voltage motors (127 or 220 V) or dual
voltage (127 and 220 V). Dual voltage motor models
allow for selecting the desired voltage according to the
electrical grid.
To correctly make the connection, see data shown
on the motor plate and the number printed on the
insulation of the wires.
For shredders sold without motor, the choice of
minimum output shall follow the technical data
shown on pg. 43.
4
5
1
Motor Installation
Model TRP 400G
3
2
6
Image for illustration purposes only
1. Stand
2. Body and cutting disc
3. Feeding funnel
4. Motor
5. Belt guard
6. Rubber pad
Attention!
Before making any connections, make sure
power source is disconnected.
1. Make sure the power source where the
shredder will be installed is compatible with
the data shown on the motor plate.
2. Disconnect the power source to make motor
connections.
3. Make the connections shown according to
the voltage of the power source.
4. To protect the wiring, use connection terminals
for the connections.
5. Make sure the connections are well insulated.
6. Turn on power source and check the rotation
of the shredder.
7. If the engine rotation needs to be reversed, note
the indication on the engine for this purpose.
4
5
1
45
Tabla de contenido
