Steinberg Systems SBS-LZ-2000SLS Manual De Instrucciones página 23

ASSEMBLING THE DEVICE
CAUTION!
If there is the concern that the device is contaminated with toxic, pathogenic,
radioactive substances or infectious test tubes with blood that are harmful to health
promptly sterilize the equipment in accordance to valid laboratory methods.
The device should be placed on a stable worktable, so that the four rubber feet of
the device adhere well to the even surface of the table. Then, insert one power plug
into the power socket at the back of the device. Connect the other end of the plug
to the power socket.
Caution! The power socket must be grounded. This will reduce the risk of electric
shock.
3.3.
Device use
Step 1:
- Set the power switch (in the lower right corner of the control panel) to the "I"
position, the device turns on. When the power switch is in the "O" position, the device
is turned off.
Step 2:
- Check if the round nut in the impeller is loose. If so, tighten it.
Step 3:
- Prepare test tubes. Place the test fluids in the tubes. Remember that they should be
on the same level.
Step 4:
- Place the tubes symmetrically on the tube rack. Tubes must be arranged
symmetrically, otherwise it will cause strong vibrations in the centrifugation process
which may lead to a serious accident.
Step 5:
- Close the lid and make sure it is locked.
Step 6:
- Set the parameters.
Manual rev. 10.02.2021 8 of 12