Denon DVD-2910 Instrucciones De Operación página 9

(5) Connecting a basic 5.1-channel surround system
Analog 5.1-channel audio signals can be output from the DVD-2910.
The multichannel audio signals recorded in packed PCM and the multichannel Super audio CDs can be played
when an AV amplifier equipped with analog 5.1-channel audio inputs is connected.
DVD-2910
Front speaker (left)
Surround speaker (left)
AV amplifier with 5.1-channel
NOTES:
• For multi-channel connections, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "MULTI
CHANNEL" and make the "SPEAKER CONFIGURATION", "CHANNEL LEVEL" and "DELAY TIME" settings.
(See pages 19, 20.)
• With the DVD-2910, we recommend turning the digital output off by using the PURE DIRECT MODE and
only outputting analog signals in order to keep interference from the digital output circuitry to the minimum
and allow you to enjoy high bit, high sampling frequency, high quality multi-channel sound. (See page 24.)
To power outlet
Center speaker
Front speaker (right)
Subwoofer
Surround speaker (right)
input terminals
(6) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See page 19.)
• "DIGITAL OUT" → "PCM"
"LPCM (44.1 kHz / 48 kHz)" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-2910
Optical fiber cable (commercially available)
75 Ω/ohms pin-plug cable (commercially available)
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to record
Super Audio CDs.
(7) Connecting to a Stereo Component
DVD-2910
NOTE:
• When connecting to a 2-channel audio stereo device using the 5.1ch AUDIO OUT, set "AUDIO
CHANNEL" under "AUDIO SETUP" on the "SETUP" to "2CH (SRS OFF) " or "2CH (SRS ON) " (See
page 19.). For multi-channel sources, the signals are down-mixed into two channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
ENGLISH
B
8 9
Digital audio input
Digital audio
connector (OPTICAL)
input
connector
(COAXIAL)
(or)
Stereo component
9