Charging The Battery; Inserting The Battery; Removing The Battery; Fitting The Accessory Tool - Hilti SBT 4-A22 Manual De Instrucciones Original

5.1 Charging the battery

1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.

5.2 Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.

5.3 Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting and adjusting the side handle
CAUTION
Risk of injury by accidental starting!
▶ Make sure that the forward / reverse switch is in the middle position
(switch-on interlock engaged) or that the battery has been removed from
the drill / driver.
▶ Fit or adjust the side handle.

5.5 Fitting the accessory tool

1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck
firmly by hand until tight and several clicks are heard.
5. Check that the accessory tool is held securely.
10 English
2
2184702
*2184702*