Preparations At The Workplace; Charging The Battery; Inserting The Battery; Removing The Battery - Hilti NURON TE 500-22 Manual De Instrucciones

Total vibration
Chiseling in concrete (a
Uncertainty (K)
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 19
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
1. Switch the product off.
2. Release the side handle clamping band by turning the handle grip.
3. Slide the side handle clamping band over the chuck from the front and into the recess provided.
4. Adjust the side handle to the desired position.
5. Tighten the side handle clamping band by turning the handle grip.
5.5

Setting the power level

After the battery is inserted, the product is always set by default to full power.
1. Press the "button for half power". The product runs at half power.
▶ The "half power indicator" lights up.
2. Press the "button for half power" again. The product runs at full power.
▶ The "half power indicator" goes out.
22 English
)
h
2
B 22­110 9.2 m/s²
B 22­255 7.8 m/s²
1.5 m/s²
2310391
*2310391*