Preparations At The Workplace; Charging The Battery; Inserting The Battery; Removing The Battery - Hilti NURON TE 30-22 Manual De Instrucciones

and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values
Sound (power) level
Uncertainty for the sound power level / sound level
Sound pressure level (L,
Uncertainty for the sound pressure level (K
Total vibration
Chiseling (a )
h, Cheq
Hammer drilling in concrete (a
Uncertainty
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 20
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove in the product.
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
22 English
)
pA
)
pA
)
h, HD
3
102 dB
3 dB
91 dB
3 dB(A)
B 22­85 7.4 m/s²
B 22­255 8.4 m/s²
B 22­85 11.4 m/s²
B 22­255 10.7 m/s²
1.5 m/s²
2264906
*2264906*