Settings; System Setting; Alarm Setting - Henry Schein MD300K2 Instrucciones De Uso

5 SETTINGS

5.1 System Setting

Pick and enter the [System Setting] interface from the main menu. And then press the Navigation buttons
to select di erent item to set.
Fig.5.1 Fig.5.2
Alarm Volume: you can adjust the value of alarm volume, there are 7 levels, and the default level is 3
Alarm Pause: there are two modes, 60s and 120s, and the default mode is 120s. The device audibly alarm
upon new alarm conditions.
Beep Tone: the level is from 0 to 7, and the default level is 3.
Backlight Setting: the level of brightness is from 1 to 7, and the default level is 3.
Language: English, French, German, Spanish, Italian, Japanese, Russian and Chinese.
Screen Sleep Mode: 1minute, 10 minutes, 30 minutes, screen always on, and the default is 1 minutes
Charging management: Charging activated, Charging stop.
ID setup: ➀ press OK button, ➁ press Navigation button to change the number, ➂ press OK button to
confirm.
Factory Default: recover to factory reset.
Note:
1. Every time enter into the Alarm Volume and Alarm Pause, you should input the password, refer to Alarm
Setting.
2. The ID range is 1~127.

5.2 Alarm Setting

Pick the [Alarm Setting] interface from the main menu. Before setting, please enter password (1234) to set
the parameter. Or you can direct access to check the parameter but not to change.
13