Measurement Screens - Henry Schein MD300K2 Instrucciones De Uso

Pulsooxímetro de mano
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
2. Insert the SpO probe into the probe socket (refer to Fig.4.1).
If the SpO probe is disconnected from the unit, a prompt
"Probe O " will be shown in the status bar in the top left of
the display screen.
Note: The probes that specified for this device conform to the
ISO80601-2-61 standard. The connector is also applied to
uploading data to MedView software for reviewing. For detailed
information, refer to the instruction manual of MedView soft-
ware.
After finishing the time setting, plug your finger into the sensor as shown in the following illustration.
Select the suitable sensor in terms of type and dimension.

4.2 Measurement Screens

There are two display modes as shown in the following pictures.
Fig.4.3 (Digital Mode)
Description of measurement screens:
1. Measuring: The pulse oximeter is in the status of measuring.
❚ It shows "Finger o " when there is no finger inserted or no signal is detected.
❚ It shows "Probe o "when the sensor/probe is not connected to the pulse oximeter.
2. SpO %: SpO area of display
❚ It shows the oxygen saturation level of functional hemoglobin during normal measurement.
❚ The color of the SpO2 value will become red when the SpO2 is beyond the alarm limits.
❚ It shows two dashes throughout probe o and finger out conditions.
3. 100: SpO high alarm limit; 90: SpO low alarm limit.
Note:
Fig.4.2 Placement of the sensor
- 9 -
probe is
Fig.4.4 (Wave Mode)
Fig.4.1
- 9 -
11
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

900-8275900-8277900-8278

Tabla de contenido