Gemini CDJ-700 Manual De Instrucciones página 17

m i d i c o n t r o l s
m i d i c o n t r o l s
midi mode
The CDJ-700 has MIDI mode, which allows the data from
the buttons and dials of the CDJ-700 to be encoded into
MIDI format. If the unit is connected via a USB cable to a
computer with MIDI-compatible DJ software, the DJ soft-
ware can be operated from the unit. The computer audio
can also be played from the CDJ-700's outputs.
It may not be possible to use some buttons to operate the
DJ sofware. For a list of MIDI messages refer the the MIDI
Device Messages Table.
noTe For instructions for your specific DJ software's
settings refer to your DJ software's operating manual.
H id mo de
In addition to MIDI, the CDJ-700 also uses HID protocol which
allows greater speeds.
If your software supports HID devices, disable MIDI devices in
your software, and search for HID devices. This should locate
the CDJ-700 and allow you to use it as a HID device.
17
m i d i d e v i c e m e s s a g e s t a b l e
con F ig UR in g m id i mo de
Connect the USB cable from the unit's rear USB port (D) to
the computer. Press the MIDI source selection on the CDJ-
700 (20). This will terminate playback of the CD/USB/SD
sources.
The CDJ-700 will then display an audio configuration
prompt for audio bit rate and sampling rate on the touch
screen with the following audio settings:
• 24-bit/192kHz
• 24-bit/96 kHz
• 24-bit/48 kHz
• 16-bit/44.1 kHz
Press and hold the MIDI source select button to swtich
between audio settings. Press MIDI to toggle between audio
settings and press the ENCODER (14) to apply the setting.
Press BACK (15) to exit.
noTe
Higher bit depth and sampling rates will create
greater latency and may impact performance.
After configuring the audio settings on the CDJ-700, start
the DJ software:
• Select the CDJ-700 as your MIDI device*
• Select the CDJ-700 as your AUDIO device*
*Refer to DJ software's instructions
-
c d j 7 0 0 m a n u a l • g e m i n i d j
.
c o m