Bench Mounting - Makita DLS713 Manual De Instrucciones

INSTALLATION

Bench mounting

When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. Release the stop-
per pin by simultaneously applying a slight downward
pressure on the handle and pulling the stopper pin.
1
► 1 . Stopper pin
WARNING:
• Ensure that the tool will not move on the
supporting surface. Movement of the miter
saw on the supporting surface while cutting may
result in loss of control and serious personal
injury.
This tool should be bolted with two bolts to a level and
stable surface using the bolt holes provided in the tool's
base. This will help prevent tipping and possible injury.
181 mm
► 1 . Bolt
Turn the adjusting bolt clockwise or counterclockwise
so that it comes into a contact with the floor surface to
keep the tool stable.
1
8.5 x 2
181 mm
1
► 1 . Adjusting bolt
Installing the holders and holder assemblies
NOTE: In some countries, the holders and holder
assemblies may not be included in the tool package
as standard accessory.
The holders and the holder assemblies support work-
pieces horizontally.
Tighten the fence shafts to the holder assemblies using
the hex wrench.
4
3
1
► 1. Holder 2. Holder assembly 3. Fence shaft 4. Hex wrench
Install the holders and the holder assemblies on both side as
shown in the figure. When installing, make sure that the fence shaft
is in the same line of the guide fence when installed to the tool.
2
1
► 1 . Holder 2. Holder assembly 3. Screw
7 ENGLISH
2
3