Makita DLS713 Manual De Instrucciones página 21

Wood facing
Use of wood facing helps to assure splinter-free cuts
in workpieces. Attach a wood facing to the guide fence
using the holes in the guide fence.
See the figure concerning the dimensions for a sug-
gested wood facing.
Over 15mm (5/8") Over 420mm (16-1/2")
1
85mm 70mm
(3-3/8") (2-3/4")
► 1 . Holes
CAUTION:
• Use the straight wood of even thickness as the
wood facing.
WARNING:
• Use screws to attach the wood facing to the
guide fence. The screws should be installed
so that the screw heads are below the sur-
face of the wood facing so that they will not
interfere with the positioning of the material
being cut. Misalignment of the material being
cut can case unexpected movement during the
cutting operation which may result in a loss of
control and serious personal injury.
NOTICE:
• When the wood facing is attached, do not turn the
turn base with the handle lowered. The blade and/
or the wood facing will be damaged.
Cutting repetitive lengths
CAUTION:
For the tool equipped with the hold-
ers and the holder assemblies as standard acces-
sories, this type of use is not permitted due to the
country regulations.
► 1 . Set plate 2. Holder 3. Screw
When cutting several pieces of stock to the same
length, ranging from 220 mm (8-5/8") to 385 mm (15-
1/8"), use of the set plate (optional accessory) will facil-
itate more efficient operation. Install the set plate on the
holder (optional accessory) as shown in the figure.
50mm-60mm
(2"-2-3/8")
27mm (1-1/16")
1
70mm 85mm
(2-3/4") (3-3/8")
1
2
3
Align the cutting line on your workpiece with either the
left or right side of the groove in the kerf board, and
while holding the workpiece from moving, move the
set plate flush against the end of the workpiece. Then
secure the set plate with the screw. When the set plate
is not used, loosen the screw and turn the set plate out
of the way.
NOTE:
• Use of the holder-rod assembly (optional acces-
sory) allows cutting repetitive lengths up to
2,200 mm (7.2 ft) approximately.
Groove cutting
► 1 . Cut grooves with blade
A dado type cut can be made by proceeding as follows:
Adjust the lower limit position of the blade using the
adjusting screw and the stopper arm to limit the cutting
depth of the blade. Refer to "Stopper arm" section
described on previously.
After adjusting the lower limit position of the blade, cut
parallel grooves across the width of the workpiece using
a slide (push) cut as shown in the figure. Then remove
the workpiece material between the grooves with a
chisel.
WARNING:
• Do not attempt to perform this type of cut
by using a wider type blade or dado blade.
Attempting to make a groove cut with a wider
blade or dado blade could lead to unexpected
cutting results and kickback which may result in
serious personal injury.
• Be sure to return the stopper arm to the
original position when performing other than
groove cutting. Attempting to make cuts with
the stopper arm in the incorrect position could
lead to unexpected cutting results and kickback
which may result in serious personal injury.
21 ENGLISH
1