Changing Parameters In The Mechanic Level (B) In The Da40Ms02 Controls - DURKOPP ADLER 271 Instrucciones De Manejo

8.1.8 Changing Parameters in the Mechanic Level (B) in the DA40MS02 Controls.

Activating the mechanic level (programming level B).
–
Press the M+ and V+ keys at the same time and hold down.
–
Turn the mains switch on.
–
Turn display mode 4 on (see Chapter 8.1.2)
Display
Display mode: Parameter and Parameter Value
Number Meaning
1-3 Parameter
4 Programming level
5-8 Parameter value
Selecting parameters and changing the parameter value.
–
= Press the C>> key, the number 1 in the display blinks, sewing is not longer possible.
–
Press the V+ key, the value of the blinking number is increased or
Press the V- key, the value of the blinking number is decreased.
–
Press the C>> key, the numbers 2-3 in the display blink.
–
Press the V+ key, the value of the blinking number is increased or
Press the V- key, the value of the blinking number is decreased .
–
Repeat this procedure until the numbers 1-3 show the desired parameter value.
–
Press the C>> key, the numbers 5-8 in the display blink (parameter value).
–
Press the V+ key, the value of the blinking number is increased or
Press the V- key, the value of the blinking number is decreased .
–
Repeat this procedure until the numbers 5-8 show the desired parameter value.
–
Press the M+ or M- key, the blinking is ended, the change is thus saved, sewing is
possible again.
56
ATTENTION!
The changing of the parameter values must be conducted
very carefully because incorrectly set drive controls can
damage the machine !
All parameter values can be returned to the preset values
through a master reset. See Chapter 8.1.13
Change via:
key V+ or V-
-
key V+ oder V-