Changing Parameter Values In The Operator Level; Reducing The Maximum Speed - DURKOPP ADLER 271 Instrucciones De Manejo

7.2.4 Changing Parameter Values in the Operator Level

The parameters of the operator level are in the parameter list of chapter 7.1.3.
–
Turn the main switch on
–
Press the "P" key. The first parameter at the operator level ,F-000, is shown.
–
The next or the previous parameter can be called up by pressing the "+" or "-" keys.
–
Press the "E" key. The value of the selected parameter is shown.
–
The parameter value can be changed with the "+"or "-" keys.
–
Press the "E" key. The changing is saved and the next paramater is shown
or
Press the "P" key, the change is saved and the programming level exited.

7.2.5 Reducing the Maximum Speed

In order to optimally set the maximum speed of the machine to the current individual
application, a reduction of the maximum speed is possible.
During sewing the display continuously shows the controls type "dA220C". The
maximum speed is shown and also changed by pressing the "+" or "-" key. The setting
range lies between the parameter values F-111 (maximum value) and F-121 (minimum
value).
Note!
There are two settings for the maximum speed: The value of the parameter 111 and the
reduction of the maximum speed through the "+/-" keys. The lower value always has
priority! When the maximum speed has been reduced with the "+/-" keys, an increase of
the parameter value 111 only becomes effective after the reduction has been cancelled.
36
ATTENTION!
The changed parameter values are only then saved to
memory, when, after exiting the programming level, a
complete seam is sewn, that is, step the pedal foreward
and then completely back.
When, after exiting the programming level, the drive is
immediately shut off, the changes are lost.
ATTENTION!
The maximum speed (value of the parameter 111) should
be set not higher than is listed in the parameter sheet (in
the accessories pack) for each class and subclass.