Maintenance And Service - Garland 105 E Manual De Instrucciones

If when introducing material for shredding, you hear
strange noises, stop the machine immediately.
In these cases, you should:
1. Disconnect the machine from the mains.
2. Loosen the opening knob.
3. Open the top section of the shredder.
4. Clean and remove excess material from the hopper,
from the blades and from the ejection mouthpiece.
5. Check the blades for damage or on the blade holder.
a) If damages exist, you must repair these before
using again.
b) If there are no damages close the shredder
again.
6. Close the cover of the shredder.
7. Tighten the opening knob.
8. Press the restart button.
9. Start shredding again with a smaller quantity and
with lighter material.
Shredding tips:
If the material to be shredded contains big quantities
of water and resin, it can block the shredder. We
suggest you allow these materials to dry first.
Bigger branches are shredded best straight after
cutting. If allowed to dry, the shredder will need more
effort for the same job.
If you are going to shred branches and pruning
remains, alternate these to minimize blockages.
7.1. FINISHING USAGE
When you stop using the machine:
1. Disconnect the machine by placing the switch in
the ¨O¨ position.
2. Unplug the machine from the mains.
3. Clear the hopper and the ejection area.
4. Open the cover and remove any rests of material
from the blades.

8. MAINTENANCE AND SERVICE

The removal of security devices, an incorrect
maintenance or the substitution of spare parts and
accessories by non originals could cause severe
injuries.
Always carry out maintenance or service
work with the machine unplugged from
the mains.
Make sure that all moving parts are at a
standstill before starting to service the
machine.
Carry out the stated maintenance
31/112
English