Maintenance And Service - Garland CHIPPER 250 E Manual De Instrucciones

English
7.1. FINISHING USAGE
When you stop using the machine:
1. Disconnect the machine by placing the switch in
the ¨O¨ position.
2. Unplug the machine from the mains.
3. Clear the hopper and the ejection area.
4. Open the cover and remove any rests of material
from the blades.

8. MAINTENANCE AND SERVICE

The removal of security devices, an
incorrect maintenance or the substitution
of spare parts and accessories by non
originals could cause severe injuries.
Always carry out maintenance or service
work with the machine unplugged from
the mains.
Make sure that all moving parts are at a standstill
before starting to service the machine.
Always wear gloves when carrying out maintenance
work to avoid damages.
When checking the blades, please remember that
although the blades are at a standstill, these can be
moved by hand. Be careful.
Carry out the stated maintenance work to ensure
the proper functioning of the machine once we
have fi nished using the machine to ensure it works
correctly in a future occasion.
Maintain your machine clean and in a good general
state. Clean the hopper and the ejection mouthpiece.
Remove dirt from the refrigerating areas so as not to
damage the engine and/or cause a fi re.
Do not clean the machine with water. The electric
engine could be damaged.
Periodically check the cables for damages through
wear and tear. If any of the cables are damaged, take
the machine to your nearest after sales service.
Do not use the machine if the cable is damaged.
8.1. ADJUSTING THE CUTTING MECHANISM
The cutting mechanism of this machine is composed of
a wheel with sharp teeth (A) that cuts the material when
the material passes between wheel A and plate B.
The distance between plate B and the teeth of wheel
A can be regulated with the regulating screw (1). To
shred material the normal distance between A and B
is between 0.5mm and 1 mm.
• To soften materials increase the distance between
A and B rotating in the CRUSH direction (to the left)
half a turn with the regulating pin.
• For lighter materials, decrease the distance
between A and B rotating in the CUT direction (to
the right) half a turn with the regulating pin.
After adjusting the distance between A and B make
sure that there is no direct contact between the
cutting wheel (A) and the plate (B). If the cutting
32/96