Garland 105 E Manual De Instrucciones página 32

English
work to ensure the proper functioning of the machine
once we have finished using the machine to ensure it
works correctly in a future occasion.
Maintain your machine clean and in a good general
state. Clean the hopper and the ejection mouthpiece.
Remove dirt from the refrigerating areas so as not to
damage the engine and/or cause a fire.
Do not clean the machine with water. The electric
engine could be damaged.
Periodically check the cables for damages through
wear and tear. If any of the cables are damaged, take
the machine to your nearest after sales service.
Do not use the machine if the cable is damaged.
When checking the blades, please remember that
although the blades are at a standstill, these can be
moved by hand. Be careful.
8.1. SUBSTITUTION OF THE BLADES
The blades suffer wear and tear through use and it
will be necessary to substitute them periodically. Carry
out the following steps:
1. Ensure that the machine is switched off and
unplugged from the mains.
2. Loosen the opening knob.
3. Lift the top cover. In this moment you shall see
the blades.
We recommend that you use security gloves from
here on to avoid possible cuts.
Opening knob
Blade
Blade
4. Block the blade holder by using a screwdriver.
5. Loosen the blades.
Note: Blades have two cutting edges. You can turn
the blades around 180 and use the new edge. If this
edge is also blunt, we recommend that you change
the blades.
Blades can be filed but this operation can only be
carried out by a professional with experience because
if the blades are not left in equilibrium, the shredder
will vibrate strongly and therefore the machine will be
dangerous for the end user.
6. Turn the blades or substitute.
7. Tighten the blades with the disc blocked (tightening
par 12Nm).
8. Close the cover.
9. Tighten the opening knob.
32/112