The Handle Installing; Electrical Connection; Design And Function - CASO DESIGN DryAged Master 63 Manual De Instrucciones

14.5.3

The handle installing

• Before connecting the device, compare the connection data (voltage and frequency)
on the rating plate with those of your electrical network. This data must agree in order
that no damages occur in the device. If in doubt, ask your qualified electrician.
• The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under or
over hot or sharp surfaces.
• This unit is not designed to be installed in an RV or used with an inverter.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.

15 Design and Function

This chapter provides you with important safety notices on the design and function of
the device.
The device comes with one metal
stainless steel handle. To install simply
screw them to the door with the supplied
screws.
To do this, slide the rubber seal on the
back of the door to the side to lay open
the predrilled holes. Use the included
screws to install the handle on the door.

14.6 Electrical connection

In order to ensure the safe and trouble-
free operation of the device, the following
instructions must be observed for the
electrical connection:
38