The Handle Installing; Electrical Connection; Design And Function - CASO DESIGN DryAged Master 125 Manual De Instrucciones

14.5.1

The handle installing

your electrical network. This data must agree in order that no damages occur in the
device. If in doubt, ask your qualified electrician.
• The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
• This unit is not designed to be installed in an RV or used with an inverter.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.

15 Design and Function

This chapter provides you with important safety notices on the design and function of the
device.
The device comes with one metal stainless
steel handle. To install simply screw them
to the door with the supplied screws.
To do this, slide the rubber seal on the
back of the door to the side to lay open the
predrilled holes. Use the included screws
to install the handle on the door.

14.6 Electrical connection

In order to ensure the safe and trouble-free
operation of the device, the following
instructions must be observed for the
electrical connection:
•
Before connecting the device,
compare the connection data (voltage and
frequency) on the rating plate with those of
39