Description Of The Device - Honeywell MILLER 1018015 Manual Del Usuario

MILLER TURBOLITE
SPECIFICAL USER INSTRUCTION

DESCRIPTION OF THE DEVICE :

Webbing retractable fall arrester 2m length
(See chart below with versions)
Protective housing in high impact nylon
25,4mmx1,52 mm PES Vectran webbing
Stainless steel braking system
Stainless steel swivel
Fig . 1
Fig . 2
Fall Indicator (fig .1) :
A fold sewn into the webbing lifeline above the snap hook serves as the impact
indicator. A warning flag is included and will be exposed should the lifeline be
subjected to fall arresting forces (equipment to remove from service).
Marking (fig2)-blaming :
(1) Block validated at up level for worker up to a 136kg user. For lateral
movements, limitation to 30° with respect to vertical is not applicable to the
Turbolite 2m webbing range.
(2) Use of the block at the down level possible (below the back D ring and not
lower than foot level), except there is a risk of contact between webbing and
an edge during the fall arrest (100kg max) Horizontal use is possible (fixed
anchorage located above the level of the dorsal D-link): allow a clearance of 4.30
m beneath the feet of the user while making sure that there is no risk of falling
onto an edge.
(3) check the locking of the block before use
(4) attach the equipment to the back D ring of the harness (fall arrest point
EN361)
Remove from service if fall indicator activated
Upside down use of the block possible (ref. recommended 1018015/1018013/
1017900/1029891/1029901/1029903)
Take care that the ScaffHook side of the block is not connected to the back D
ring harness (*)
Adapt the fall clearance according the extra lanyard out of the unit and the work
angle(general manual user: « space clearance »)
Periodic examination :
For the annual inspection, this device doesn't need to be return to the
manufacturer. For this operation, please refer to the general manual user (§ «
checking before use » and « periodic examination »). Remove the product from
service if any failure is detected)
88