Selecting A Location - STACK-ON QAS-450 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
• For security you must program your own
combination after opening the safe.
• Record this new combination on this form or
store your combination on our secure website at
www.stack-on.com under Service. If you write
down your combination you must keep this
information in a secure place, away from
children, not inside the safe.
1.
Press the Reset Button (5) located inside the safe.
Two "beeps" will sound.
2.
Enter your own 3-8 button combination by
pressing any combination of the 3 buttons.
NOTE: A "beep" will sound when the button is
successfully pushed.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
3. Press the Reset Button again. After two
"beeps" your new combination is recorded.
Reset Button
OPENING THE SAFE USING
YOUR COMBINATION
Enter your combination using the buttons. If 2
"beeps" sounds and the green light goes on, the door
will open. If an incorrect combination is entered 4
short "beeps" will sound.
NOTE: If you enter a wrong combination 3 times,
the control pad will lock out for 5 minutes.
To close the safe, push the door closed until locked.

SELECTING A LOCATION

The safe must be mounted to a shelf. For optimal
safety and security, the safe should be installed in
an isolated, dry and secure area.
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
3
18
40286-1307
Tabla de contenido
loading

Tabla de contenido