External Aerial; Power Supply; Plug In Receiver; Usb Connector - V2 CITY4-EVO Manual De Instrucciones

5.13 - EXTERNAL AERIAL

We suggest to use the external aerial (model: ANS433) in order to
guarantee the maximal range.
Connect the antenna hot pole to terminal L1 of the control unit
and the braiding to terminal L2.
L1 L2 L3 L4 L5 L6 L7 L8 L9 L10 L11

5.14 - POWER SUPPLY

The control unit must be fed by a 230V - 50Hz (120V - 50/60Hz
for 120V model) electric line, protected by a differential
magnetothermal switch complying with the law provisions in
force.
Connect power supply cables to terminals L and N.
230V - 50Hz

6 - PLUG IN RECEIVER

CITY4-EVO is suitable for plugging in a Personal Pass MR receiver.
m
removable modules.
MR1 module receiver is provided with 4 channels and each of
them is suitable for a command of CITY4-EVO control unit::
• CHANNEL 1
• CHANNEL 2
• CHANNEL 3
• CHANNEL 4
The transmitter codes can be stored in two ways:
1. By pressing the P1 button on the MR receiver (read the
instructions supplied with the receiver)
2. Using WINPPCL software: to run the program you need to
connect a PC to the control unit. The connection can be made
via USB using a standard USB cable.

7 - USB CONNECTOR

The CITY4-EVO unit is equipped with an USB connector for
connection with a PC.
By using software V2+ (version 2.0 or higher), it is possible to
carry out the following operations:
1. Firmware update of the unit.
2. Change of programming parameters.
3. Reading information of diagnostics.
If the unit is not fed, by connecting the USB cable to the unit and
the PC, the display switches on and caption
this stage only the programming operations through the PC can
be carried out.
If the unit is fed, by connecting the USB cable to the unit and the
PC, the display continues to display the control panel: in this stage
the programming operations through the PC, can be carried out,
or control the gate.
N L
NOTE: to carry out the firmware updating, it is necessary to
disconnect the unit network power supply (during updating
the display is switched off).
All other operations can be carried out while the unit is
power supplied.
- 38 -
WARNING: Pay attention to the way you connect the
g
START
g
PEDESTRIAN START
g
STOP
g
COURTESY LIGHT
-USb
is displayed: in