Section 2 System: Introduction; How To Use This Manual; Equipment Identification; Receipt Of Equipment - ESAB Cutmaster 60 Manual De Instrucciones

SECTION 2 SYSTEM:
INTRODUCTION

2.01 How To Use This Manual

This Owner's Manual applies to just specification
or part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
CAUTION, DANGER, and NOTE may appear.
Pay particular attention to the information
provided under these headings. These special
annotations are easily recognized as follows:
NOTE!
A n o p e r a t i o n , p r o c e d u r e , o r
b a c k g r o u n d i n f o r m a t i o n w h i c h
requires additional emphasis or is
helpful in efficient operation of the
system.
CAUTION
!
A procedure which, if not properly
followed, may cause damage to the
equipment.
WARNING
!
A procedure which, if not properly
followed, may cause injury to the
operator or others in the operating
area.
WARNING
Gives information regarding possible
electrical shock injury. Warnings will
be enclosed in a box such as this.
DANGER
Means immediate hazards which, if
not avoided, will result in immediate,
serious personal injury or loss of life.
A d d i t i o n a l c o p i e s o f t h i s m a n u a l m a y b e
purchased by contacting ESAB at the address
and phone number in your area listed on back
cover of this manual. Include the Owner's Manual
number and equipment identification numbers.
300x5395
Electronic copies of this manual can also be
downloaded at no charge in Acrobat PDF format
by going to the ESAB web site listed below
http://www.esab.eu

2.02 Equipment Identification

The unit's identification number (specification or
part number), model, and serial number usually
appear on a data tag attached to the rear panel.
Equipment which does not have a data tag such
as torch and cable assemblies are identified only
by the specification or part number printed on
loosely attached card or the shipping container.
Record these numbers on the bottom of page i for
future reference.

2.03 Receipt Of Equipment

When you receive the equipment, check it
against the invoice to make sure it is complete
and inspect the equipment for possible damage
due to shipping. If there is any damage, notify
the carrier immediately to file a claim. Furnish
complete information concerning damage claims
or shipping errors to the location in your area
listed in the inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of
the parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging
the equipment when using bars, hammers, etc.,
to un-crate the unit.
INTRODUCTION
ESAB CUTMASTER 60
2-1