Introduction; Technical Data; Controls And Conectors - ESAB Origo Feed 304N P4 Manual Del Usuario

2 INTRODUCCION
™
The Origo Feed 304N P4 wire feeders are designed for semi-automatic MIG/MAG welding with solid wires,
cored and aluminium in services of average and heavy production.
They have a wire feed mechanism of 4 feed rollers engaged and an electronic control system. They can be
installed on the power source or on a wheel kit to move it around the workplace (optional).
3

TECHNICAL DATA

Power supply (V - Hz)
Wire feed speed (m/mm)
Wire diameter (mm)
Solid steel
Cored wire
Aluminium
Welding gun connection
Digital Voltmeter/ampermeter
2/4 Stroke
Welding source voltage setting
Manual feeding of the wire
Remote control
Bobbin cover
Burnback (sec.)
Dimensions (W x L x H) (mm)
Weight (kg)
4 CONTROLS AND CONNECTORS
4.1) Front panel
1- Knob for setting wire feed speed.
2- Knob for setting the voltage.
3- Digital voltmeter/ampermeter. To display the parameters of welding, voltage and current. After the
welding it maintains the set values shown on the display.
4- Connector for welding gun.
5- Interruptor of manual wire release - Allows the wire to be fed without voltage in the welding gun.
6- Remote/panel switch - to select the control by front panel OrigoFeed 304N P4 or by remote control.
7- Remote socket - connector for the remote control
4.2) Side console
8- Burnback - Burnback time is a delay between the time when the wire starts to brake until the time when
the power source switches off the welding voltage.Too short burnback time results in a long wire stickout
after completion of welding, with a risk of the wire being caught in the solidifying weld pool. Too long a
burnback time results in a shorter stickout, with increased risk of the arc striking back to the contact tip.
9- 2/4 Stroke - With 2 stroke
released. With 4 stroke
when it is released. The welding process continues until the switch is pressed in again, the wire feed
stops and when the switch is released the gas stops flowing.
10- Wire feed mechanism.
All manuals and user guides at all-guides.com
, wire feed starts when the trigger switch is pressed in and ends when it is
, the gas flow starts when the trigger switch is pressed in and the wire feed starts
42 - 50/60
1,5 - 22,0
0,6 - 1,6
1,0 - 2,4
0,8 - 1,6
Euro-conector
Optional
230 x 570 x 380 (without bobbin cover)
230 x 570 x 455 (with bobbin cover)
- 22 -
Y es
Y es
Y es
Y es
Y es
0 - 0,5
15,4