ESAB Cutmaster 60 Manual De Instrucciones página 100

ESAB CUTMASTER 60
WARNING
!
Always turn OFF the air supply and bleed the system before disassembling the Filter
Assembly as injury could result.
3. Loosen the two bolts on the top of the Filter Assembly enough to allow the Filter Elements to
move freely.
4. Note the location and orientation of the old Filter Elements.
5. Slide out the old Filter Elements.
6. Slide the replacement Filter Elements into the Filter Assembly, with the same orientation as
noted in Step 4 above.
7. Hand tighten the two bolts evenly, then torque each bolt to 20 - 30 in-lbs (2.3 - 3.4 Nm).
Improper torque may damage the gasket.
8. Slowly apply air pressure to the assembly, checking for leaks.
NOTE!
A small amount of air leakage from the bottom fitting is normal.
This completes the parts replacement procedures.
5-8
First & Second
Stage
Cartridges
(as marked)
Optional Two-Stage Filter Replacement
SERVICE
Art # A-02942
300x5395