Safety Information; Layout And Items Supplied; Technical Data - HERKULES H-FS 920/1 Manual De Instrucciones

Anleitung_H_FS_920_1_SPK7:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety information

Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.

2. Layout and items supplied

6/14)
2.1 Layout
1. Miter stop
2. Parallel stop
3. Wheel guard
4. Cutting table
5. Water trough
6. Housing
7. Knurled screw for setting the angle
8. Scale for miter cut
9. Knurled screw
10. Thumb screw
11. Holder for splitter
12. On/Off switch
13. Switch housing
15. Diamond cutting wheel
16. Outer flange
17. Side cover
18. Nut
19. Splitter
20. Fastening screws for splitter holder
2.2 Supplied package
the packaging and take out the equipment with
care.
Remove the packaging material and any
10
20.01.2012 8:15 Uhr Seite 10
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions
Safety information

3. Technical data:

Motor rating:
Motor speed:
AC motor
Insulation material class
Protection type
(Fig. 1-
Protection class
Cut length:
Jolly length:
Cutting height 90°:
Cutting height 45°:
Cutting table-Dimensions
Diamond cutting wheel
Weight:
A load factor of S2 10 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (900 W) for no longer than
the time stipulated on the specifications label (10
minutes ON period). If you fail to observe this time
limit the motor will overheat. During the OFF period
the motor will cool again to its starting temperature.
Noise emission values
The noise generated by this equipment is measured
in accordance with DIN EN ISO 3744; 11/95. The
machine may exceed 85 dB (A) at the workplace.
The user will require noise protection measures if
this is the case. (Wear ear-muffs!)
900 W S2 10 min
2950 rpm
230 V ~ 50 Hz
Class B
IP 20
I
Unlimited
Unlimited
41 mm
25 mm
500 mm x 400 mm
ø 200 x ø 25.4 mm
13 kg