TRAPP TRF 50 Manual De Instrucciones página 61

www.trapp.com.br
Some shredder models are provided with 110/220 V
voltage selector.
Note:
if necessary, the motor protection cover
(according to the figure beside) can be removed. Some
shredder models with electric motor installed directly in
the shredder's body, allow the motor protection removal
so as to allow cleaning the residues accumulated inside
the motor protection, resulting from the dust generated
during the work. The electric motors protected by a sheet
(IP22) and gasoline-powered engine can be cleaned by
using compressed air. Such work must be conducted with
the equipment off and wearing safety glasses. Never
operate the equipment without the factory-supplied
protections.
In order to attach the rubber pad, proceed according
 
to the figure beside. Mount the rubber pad in the
frame base, by using a flat, lock washer and a nut.
Voltage Selector Switch
Rubber Pad
If necessary, adjust the motor voltage according
to the locally available power grid voltage, by
adjusting the selector as indicated in the figure.
Motor
protection
cover
Screw
Voltage
selector
switch
In order to adjust the voltage selector, it's not
necessary to open the motor protection cover, just
remove the acrylic cover located in the voltage
selector and by using a screwdriver, change the
position as desired, in order to change the selector
position, move the screwdriver parallel to the motor.
Rubber pad
61