TRAPP TRF 50 Manual De Instrucciones página 55

www.trapp.com.br
Attention!
Before making any connections, make sure power source is disconnected.
1. Make sure the power source where the shredder will be installed is compatible with the data shown on
the motor plate.
2. Disconnect the power source to make motor connections.
3. Make the connections shown according to the voltage of the power source.
4. Make sure the connections are well insulated.
5. After connecting the motor wires to the on/off switch, connect the motor to the power grid and verify
the motor rotation direction, if necessary, change the motor wire connection as indicated in the motor
to reverse the rotation.
Instructions Before Operating the Shredder
Checking:
Before operating the shredder check:
If there are tools or objects on the motor or on the
 
equipment, mainly inside the grain funnel or in the
green crop feeder.
If there is something obstructing the motor.
 
If the rotation direction is correct.
 
If the voltage of the power source is the same of that
 
of the shredder.
1
Image merely illustrative.
Belt Tensioner Start - TRF 300G
If there are no people or object close to the belt
 
pulleys or in the direction of the material to be
shredded. Keep people and children in a radius of
30 m far from the equipment.
If the shredder cover is properly closed.
 
If the counter cutting blade is properly set and
 
tightened (pg. 59).
Note:
if the equipment is properly prepared, start the
motor, allow it to reach maximum revolution and start
working.
55