TRAPP TRF 50 Manual De Instrucciones página 58

Other models
Mount the grain funnel (1) by attaching it to the green
 
crop funnel (2) according to the following image, thus,
the dry material crushing work can be performed.
After mounting the funnel, pour the grains intended
 
to be crushed in the funnel and adjust the material
output opening so as not to overload the motor during
the operation. The material can only be released from
the grain funnel when the motor is in full rotation, as
indicated in page 54.
Turning the motor on with the material inside the
 
shredder will cause the warranty to be lost.
Quirera Outlet Pipe Assembly - TRF 400F
Delivered with the fodder crusher TRF 400F:
1 quirera outlet pipe;
 
4 flat washers Ø 19 x Ø 6,35 x 1,2 mm;
 
4 spring washers 1/4";
 
4 slotted screws UNC 1/4" x 1/2".
 
Follow these steps to assemble the quirera outlet
pipe:
Fit the quirera outlet pipe (4) in the body of the
 
machine;
Insert the flat washer (3), spring washers (2) and
 
slotted screws (1) as shown below and tight as
necessary.
Remove the cover plate (1). Except for models
 
TRF 50, TRF 60 and TRF 70.
Remove the green crop feeder cover (4).
 
Remove the grain funnel (5).
 
Place a smooth sieve (2), because the output will be
 
by the upper part of the shredder. Direct the outlet
spout towards the desired material direction. Except
for models TRF 50, TRF 60 and TRF 70, where the
shredded material will be discharged by the lower
body output and the smooth sieve is not used, the
sieve is simply removed.
58
To Triturate Fodders
 
 
 
2
3
1
4
The green products are placed into the green crop
feeder (3), and then forwarded to be processed. The
end product leaves the shredder through the upper
part. Except for models TRF 50, TRF 60 and TRF 70,
where the shredded material will be discharged by
the lower body output.
When using grass or sugar cane, do not exceed the
feeding capacity so as not to overload the motor.
Exceeding the feeding capacity may block the
material output spout.
In models TRF 50, TRF 60 and TRF 70, the processed
material leaves through the lower part. Check the
machine position and the direction intended to launch
the material before turning the machine on.
www.trapp.com.br