NAMCO GUNMEN WARS Manual Del Operador página 67

1. Remove the Gun Sides (L & R).
2. Disconnect the microswitch connector.
3.
Remove the 2off flange head screws (M3x6) and remove the microswitch
complete with bracket.
4. Remove 2off pozi pan head screws (M2.3x10), with flat and spring
washers, and remove the microswitch.
5. Replace the microswitch, taking care that the microswitch wires are
connected to the correct terminals.
6. After replacing the trigger microswitch ensure that it is working properly
when the trigger is squeezed.
7. If the switch does not operate correctly adjust it by loosening the 2off
flange socket head screws (M3x6) and sliding the switch bracket
backwards or forwards. When the switch is operating correctly retighten
the 2off flange socket head screws (M3x16).
8. Reasemble in reverese order.
Refit new Gun Grip Decals (L & R).
9.
(See 8-4 page
Bracket
Microswitch
Microswitch wiring
Brown Brown
(COM) (N.C.)
Page 67
62)
Flange socket head screw
(M3 × 6)
Connector
Pozi pan head screw
(with plain and spring washer)
(M2.3 × 10)
Microswitch