Stihl MS 201 T Manual De Instrucciones página 30

English
Adjusting the Master Control lever
To adjust the Master Control lever from
run F to cold start l, press and hold
down the throttle trigger lockout and
throttle trigger simultaneously – set
master control lever.
To set the master control lever to warm
start n, first set it to cold start l, then
push the master control lever into the
warm start n position.
Switching to the warm start n position
is only possible from the cold start l
position.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the master control lever
to jump from the warm start n position
to run F.
To switch off the engine, set the master
control lever to Stop 0.
Position cold start l
– if the engine is cold
– if the engine stalls during opening of
throttle after starting
– If the fuel tank has run empty
(engine stalled out)
Position warm start n
– If engine is warm (once the engine
has been running for approx. one
minute)
– When the engine has turned over
for the first time
– After ventilation of the combustion
chamber, if the engine was flooded
28
Holding the chain saw
Place the chain saw securely on the
N
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
Hold the control handle of the chain
N
saw firmly in the right hand
Support the right knee on the
N
carburetor cover
Starting
With the right hand, pull the starter
N
grip slowly until you feel it engage –
and then give it a brisk strong pull –
simultaneously press down on the
handlebar – do not pull the starter
rope out all the way – risk of
breakage! Do not let the starter grip
snap back – guide it vertically back
into the housing so that the starter
rope can rewind properly
With a new engine or after a long period
of disuse, with machines without an
additional manual fuel pump, it may be
necessary to pull the starter rope several
times – to prime the fuel line.
Starting the chain saw
There must not be anyone within
the swivel range of the chain saw.
MS 201 T