Stihl MS 201 T Manual De Instrucciones página 39

Installing the rope rotor
1
Thread the rope from above through
N
the rope guide bush (1) and rope
rotor (2) and secure with a simple
overhand knot
Coat the bearing bore in the rope
N
rotor with non-resinous oil
Slip the rope rotor onto the starter
N
post (3) – turn it back and forth a
little until the anchor loop of the
rewind spring engages
MS 201 T
6
4
Refit the pawl (4) in the rotor and
N
slip the washer (5) over the starter
post
Press the spring clip (6) on to the
N
starter post and over the pegs of the
2
pawl with a screwdriver or suitable
pliers – the spring clip must point in
the clockwise direction – as shown
in the picture
Tensioning the rewind spring
Make a loop in the unwound starter
N
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow
Hold the rope rotor tight – pull out
N
the twisted rope and untangle it
Release the rope rotor
N
Slowly let go of starter rope so that
N
it winds onto the rotor
The starter grip must be drawn firmly
into the rope guide bush. If it tips
sideways: increase the spring tension by
5
another turn.
N
N
Replacing broken rewind spring
N
N
N
N
N
N
When the starter rope is fully
extended it must be possible to
rotate the rotor at least another
half turn. If not, the spring has
been tensioned too tightly and
may break!
Remove one turn of the rope from
the rotor
Mount the fan housing on the
crankcase
Remove the rope rotor
The broken pieces of spring may
still be under tension and can
spring apart unexpectedly on
removal from the housing – risk of
injury! Wear face shield and
protective gloves
Carefully remove broken pieces of
spring
Apply a few drops of non-resinous
oil to the new replacement spring
Position the replacement spring
with frame in the fan housing – the
anchor loop must be located over
the retaining lug in the fan housing
Apply suitable tools (screwdriver,
punch, etc.) to the recesses and
push the spring into its seat in the
fan cover – the spring slides out of
the frame
Remove the frame from the fan
housing
English
37