Instructions Before Installation - Waeco MagicWatch MWE910 Instrucciones De Montaje Y De Uso

All manuals and user guides at all-guides.com
MagicWatch MWE910
4

Instructions before installation

4.1 Determining the place of installation for the
sensors
See fig. 3 to fig. 6
Note
I
The sensors must be correctly aligned for the device to work prop-
erly.
If these point to the ground, irregularities and bumps on the surface
may be interpreted as obstacles. If they point too far up, obstacles
will not be detected at all.
Note the following during installation:
The distance from the sensors to the ground should be between 40 cm
and a maximum of 60 cm (fig. 3).
Note that the installation angle depends on the installation height.
Select the right sensor holder and the appropriate drill diameter by con-
sulting the table in fig. 3.
Install the sensors in the correct place (fig. 6):
Colour of sensor
Blue (bl)
Black (bl)
Green (gr)
4.2 Painting the sensors
See fig. 7
Note
I
The sensors may be painted. The manufacturer recommends
having the sensors painted by a specialist workshop.
Instructions before installation
Installation location
Outer sides of the rear bumper
Centre of the rear bumper
Front bumper
17