Blade Assembly; Light Kit Assembly - Craftmade ELLINGTON LS52ABZ5CRGD Manual De Instrucciones

8. Blade Assembly.

Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and align
holes. Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are installed
with blade arm screws, discard plastic motor locks (save
blade arm screws and lock washers to secure blade arms).
Align blade arm holes with motor screw holes and
attach blade arm with lock washers and blade arm
screws. Before securing screws permanently, repeat
with remaining blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.

9. Light Kit Assembly.

Remove switch housing cap from switch housing by removing 3 screws
from switch housing.
Locate BLUE (or BLACK) and WHITE wires in switch housing labeled
FOR LIGHT. Remove and discard plastic that hold these 2 wires together.
Remove hex nut and lock washer from threaded rod on light kit fitter.
Punch center cap out of switch housing cap with a screwdriver. Gently
feed wires from light kit fitter through center hole in switch housing cap.
Screw switch housing cap onto threaded rod followed by lock washer
and hex nut. Tighten hex nut over lock washer for a secure fit.
Connect WHITE wire from light kit fitter to WHITE wire from switch
housing. Connect BLACK wire from light kit fitter to BLUE (or BLACK)
wire from switch housing. Be sure that the molex connections snap
together completely. Attach light kit fitter to switch housing with screws
that were previously removed. (Note: The gap on the top edge of the
switch housing cap must align with the reverse switch on the switch
housing for the proper fit.) Securely tighten all 3 screws.
Install two 13 watt compact fluorescent medium base bulbs (included).
Important: When replacing bulbs, allow glass shade and bulb(s) to cool
down before touching.
Remove finial from threaded rod on light kit fitter. Align hole in glass
shade with threaded rod and push up gently on glass shade. Secure
glass shade to light kit fitter with finial. Do NOT overtighten finial as glass
may crack or break.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
plastic
motor
lock
lock washer
lock washer
CFL
bulb
page 7
motor
housing
blade arm
blade arm screw
center
cap
hex nut
light kit
fitter
finial
blade
attachment
screws
and washers
blade
switch
housing
switch
housing
cap
switch
housing
molex
connections
switch
housing
cap
threaded
rod
glass
shade