Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it stops.
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and
break.
Time Saver: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 12 blade attachment
screws/washers in hardware pack. Slide
blade through one of the narrow,
rectangular openings on motor housing
(please note side of blade indicating THIS
SIDE UP), aligning holes in blade with
holes in blade arm (located on the
underside of the motor housing)--refer
to drawing at right.
Then, place blade
plate under holes in blade, making sure
to align all 3 holes, as shown in drawing at
right.
Insert 3 blade attachment
screws/washers with fingers first and
then tighten screws securely with a
Phillips screwdriver. Repeat procedure for
each remaining blade.
Note: Tighten blade attachment screws
twice a year.
screw
canopy
canopy cover
motor housing
blade arm
page 7
hanging
bracket
screw
THIS
SIDE UP
(label)
blade
blade plate
blade attachment
screws/washers
Capítulos
Tabla de contenido
