Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12. Remote Control Operation.
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
FAN/OFF button - turns fan ON or OFF
TOP LIGHT button - push to activate motor housing light ON or OFF
BTM LIGHT button - push to activate light kit ON or OFF
Tapping either light button quickly turns top/bottom light ON/OFF.
Pressing TOP LIGHT light button and holding it down for more than
0.7 seconds converts it into a dimmer. Auto resume capability keeps
top light at same brightness level as the last time it was turned off.
13. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Locate ON/OFF slider switch on wall control and set to the ON
position. Test fan lights and then test speeds. Next, locate remote
control. Start with the lights OFF and test the light ON/OFF function
by pressing the TOP LIGHT, and then the BTM LIGHT button. Test
the dimmer function by pressing TOP LIGHT and holding it down
for more than 2 seconds. Test fan speeds with the different fan
speed buttons. (diagram 1) If the remote operates all of the
functions of the fan and light, battery has been installed correctly. If
the wall and/or remote control do/does not operate all of the fan
and/or light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Turn fan completely off before moving the reverse switch (located
on the switch housing). Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set either completely to the LEFT
or completely to the RIGHT for fan to function. If the reverse switch is
set in the middle position (diagram 4), fan will not operate.
14. Housing Bulb Replacement.
Important: Allow glass housing and light bulbs to
cool before touching.
When bulbs in lighted housing need replacement,
bulbs may be accessed from access plates on top of
motor housing. Use a Phillips screwdriver to remove
the 2 screws at either end of the access plate
containing burnt-out bulb and lift the end with
only one screw hole in it. Remove the burned-out
bulb and replace bulb with a candelabra base 15
watt max. bulb (sold separately). Re-attach access
plate with screws that were removed. Repeat for
each burnt-out bulb.
motor
housing
diagram 1
diagram 2
access
plate
bulb
page 9
reverse switch
diagram 3
diagram 4
top
of motor
housing
motor
housing
Capítulos
Tabla de contenido
