Canopy Assembly; Blade Assembly - Craftmade Ventura VEN52 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Locate 15 blade attachment screws/washers
in hardware pack. Slide blade through one of
the narrow, rectangular openings on motor
housing, aligning holes in blade with holes in
blade arm (located on the underside of the
motor housing)--refer to drawing at right.
Then, place blade plate under holes in blade,
making sure to align all 3 holes, as shown in
drawing at right. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
Note: Tighten blade attachment screws
twice a year.
screw
page 7
hanging bracket
screw
canopy
canopy cover
motor housing
blade
blade arm
blade plate
blade attachment
screws/washers