Fan Assembly. Pgs - Craftmade ELLINGTON LS52ABZ5CRGD Manual De Instrucciones

5. Fan Assembly.
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
12in. downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
12in. downrod, please proceed to instructions
following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball and remove pin and clip. Lower
hanging ball and remove stop pin. Slide hanging
ball off the original downrod, A, and slide it down
the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin
into top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the inside
of the hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from downrod (if you
have not already done so). Slide downrod through
canopy, decorative scroll arms and yoke cover.
Thread electrical wires and safety cable through
downrod and pull extra wire slack from the upper
end of the downrod.
Thread downrod into the motor housing yoke,
making sure wires do not get twisted, and then
screw downrod all the way into the yoke so that it is
secure. Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts securely.
Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
pin
A
electrical wiring
downrod
decorative
scroll arms
pin
page 4
set screw hole
stop pin
hanging ball
clip
B
safety cable
canopy
yoke cover
yoke set screw
motor
housing
clip