Canopy Assembly - Craftmade ELLINGTON LS52ABZ5CRGD Manual De Instrucciones

6. Wiring. (cont.)
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended
for use. Write down number sequence for use in
Section 10.
Since this fan comes with compact fluorescent
bulbs, the dimmer switch (labeled D and X) has
been pre-set to the "OFF" position (X). Note: Most
compact fluorescent bulbs (including the ones
provided with this fan) are not compatible for use
with dimmer controls.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front
plate to wall control using 2 screws provided with
the wall control.

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed, and then tighten both screws
securely.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
outlet box
black
(AC IN from
breaker box)
(wiring for wall control)
antenna
screw
page 6
wall
control
green/ green/ green/
bare bare bare
ground ground ground
green
black (OUT to fan)
black
black
(TO POWER supply)
receiver
hanging bracket
canopy
screw
plate
code
switches
dimmer
switch