Blade Assembly; Testing Your Fan - Craftmade Ellington GD52ABZ5 Guia De Instalacion

9. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat with
remaining blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.

10. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with pull chain
on switch housing. (diagram 1) Start at the OFF
position (no blade movement). First pull will set the
fan to HI. Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will again set
the fan to the OFF setting. If fan does not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to function.
If the reverse switch is set in the middle position
(diagram 4), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to the end of the pull
chain.
plastic
motor
lock
lock washers
diagram 1
diagram 2
page 7
motor housing
blade attachment
screws and washers
blade arm
blade arm screws
reverse switch
pull chain
extension
diagram 3 diagram 4
blade