Description Of Controls - Cebora MIG WELD 403 S Manual De Instrucciones

at the same spot as the work return lead. To do so, a second
ground clamp, fitted to the protection lead, must be atta-
ched next to the ground clamp of the work return lead.
3.3.3 Connecting the gas hose.
• Keep the cylinders in an upright position by chaining them
to their support.
• Keep the cylinders in a place where they cannot be damaged.
• Do not lift the machine with the cylinder on its support.
• Keep the cylinder away from the welding area and uninsu-
lated electric circuits.
• Cylinders containing inert gas have to be equipped with a
pressure reducer and a flowmeter.
• After having positioned the cylinder, connect the gas hose
that comes out from the rear of machine to the pressure
reducer output.
• Regulate the gas flow to 8¸10 l/min.

4 DESCRIPTION OF CONTROLS

4.1 CONTROLS ON GENERATOR FRONT PANEL
A- On/Off switch
This switch turns the machine on or off.
B- Switch
This switch adjusts the weld voltage range and, in some ver-
sions, turns the machine on and off.
C- Rotary weld voltage switch
This switch allows the fine tuning of the welding voltage
selected with switch B. (Step adjustment)
D - Impedance Taps
Connect the male end of the work return lead to one of
the three impedance taps.
4.2 CONTROLS ON GENERATOR REAR PANEL
E - 230V power supply socket.
440 W max. power. For cooling unit only. (Warning: Do not
connect other equipment to this socket.).
F - 6-pin socket connector.
For the 6-pin plug connector on extension lead.
G - Socket.
For the extension lead power supply connector ('+' pole).
H - Socket.
For connection to the safety device on the cooling unit.
N.B. If no cooling unit is used with the machine, plug the
connector supplied with the machine into the socket H.
5 WELDING
5.1 INSTALLATION AND STARTER
• Machine installation must be done by a competent staff. All
connections must correspond to the rules in force (CEI 20-
10 HD 427) and must respect laws concerning accidents.
• Check that the wire diameter corresponds to that indica-
ted on the roll and mount the wire coil.
• Connect the pipe coming out of the extension with the
cylinder flowmeter.
• Position the welding machine so as to allow free air circu-
lation inside it and avoid that metal or any other.
5.2 THE MACHINE IS READY TO WELD • Connect the ground terminal to the part to be welded.
• Turn the machine on.
• Extract the conic gas nozzle by rotating it clockwise.
• Unscrew the current nozzle.
• Press the torch trigger to feed the wire until it comes out from the torch.
WARNING: Keep your face away from the terminal nozzle
while the wire comes out.
9