Ceasa NASSER LCD HF UF WBP 160 Manual De Instrucciones página 54

Values
Set Flow
Rate Unit
Set Resin
Volumen
Interval
Regen. D.
Set Backwash Time
Set B.S.R.T
Set. B.R. Time
Set F.R. Time
Note: In the KIVU model is not necessary to modify the values of the TECHNICIAN mode (Background) because it has been programmed by the
manufacturer.
Notice: The valves are adjusted in manufacturing. In case of accessing to technical mode, please be aware that by modifying the "set
valve model" or "set type" parameters, the valves are reset and all the parameters must be entered again.
54 NASSER
All manuals and user guides at all-guides.com
Programming steps
Under the Technician model (L2)
1. Select "Set Flow Rate Unit" parameter by (▼▲)
2. Press "validation" and select Gal, L or m³ (LT4)
3. Press "validation" to return to the Technician mode ( L2)
Under the Technician model (L2)
1. Select "Set Resin Volume" parameter by (▼▲)
2. Press "validation" and adjust (▼▲) the resin volume (LT5)
3. Press "validation" to return to the Technician mode ( L2)
Under the Technician model (L2)
1. Select "Interval Regen. D." parameter by (▼▲)
2. Press "Validation" and adjust (▼▲)the days between regenerations (LT6)
3. Press "validation" to return to the technician mode (L2)
Under the Technician model ( L2)
1. Select "Set Backwash Time" parameter by (▼▲)
2. Press "validation" and adjust time according to the
3. Press "validation" to return to the Technician mode (L2)
Under the Technician model (L2)
1. Select "Set B.S.R.T." parameter by (▼▲)
2. Press "validation" and adjust time according to the
3. Press "validation" to return to the Technician mode (L2)
Under the Technician model ( L2)
1. Select "Set B.R.Time" parameter by (▼▲)
2. Press "validation" and adjust time according to the
3. Press "validate" to adjust seconds
4. Press "validation" to return to the Technician mode ( L2)
Under the Technician model (L2)
1. Select "Set F.R.Time" parameter by (▼▲)
2. Press "validation" and adjust time according to the
3. Press "validate" to return to Technician mode (screen L2)
4. Press "validation" to return to the Technician mode (L2)
- CEASA
LT4
Set Flow Rate Unit
LT5
LT6
LT7
Annex I (LT7)
LT8
Annex I (LT8)
LT9
Annex I (LT9)
LT10
Annex I (LT10)
Screen
○ Gal
● L
○ m³
Set Resin Volume
38 L
Interval Regen. D.
30 Days
Set Backwash Time
XX Minutos
Set B.S.R.T
XX Minutes
Set B.R. Time
XX:XX Minutes
Set F.R.Time
XX Minutes