Replace The Hydrophobic Filter; Replacement Parts And Accessories - OTT Flo-Dar Manual Del Usuario

Replace the hydrophobic filter

Replace the hydrophobic filter when it is torn or has become saturated
with water or grease. To examine the hydrophobic filter, refer to
the dessicant beads on page 22.
For the best performance and to avoid grease buildup during
submergence or surcharge conditions, make sure that the dessicant
cartridge is installed vertically so the end cap points down.
Note: It may be necessary to replace the hydrophobic filter any time the cartridge
is submerged or comes in contact with excess moisture.
1. Disconnect the tubing from the top of the desiccant canister.
2. Turn the hex-head tubing nipple to remove it from the top of the
canister. Discard the old filter.
3. Discard any used Teflon tape from the nipple threads.
4. Apply two turns of Teflon tape to the threads. Pull the Teflon tape
into the threads until it has the same shape as the threads.
5. Put a new filter over the hole. Make sure that the smooth side of the
filter is towards the inside of the canister. Refer to
6. Put the threaded nipple on top of the filter.
7. With a slight pressure, push the filter into the hole with the nipple
threads. Turn the nipple to install it in the hole.
The filter will bend upward and go completely into the thread until it
cannot be seen. The filter must turn with the nipple as the nipple is
turned into the cap. If the filter does not turn, it is torn. Start the
procedure again with a new filter.
8. Look in the upper cap. A small, dim light spot should be seen when
held up to the light. If a bright spot is seen, the filter is torn. Start the
procedure again with a new filter.
All manuals and user guides at all-guides.com
Replace
Figure 21.
Figure 21 Replace the hydrophobic filter
1 Filter, smooth side down
2 Hex-head tubing nipple

Replacement parts and accessories

W A R N I N G
Personal injury hazard. Use of non-approved parts may cause
personal injury, damage to the instrument or equipment malfunction.
The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the
appropriate distributor or refer to the company website for contact information.
Replacement parts
Note: Contact customer service for additional cable length options.
Description
Bail assembly
Cable assembly, 9.14 m (30 ft), connector on one end
(includes a junction box, desiccant, and a potting kit)
Cable assembly, 9.14 m (30 ft), connector on both ends
Cable assembly, 18.29 m (60 ft), connector on one end
(includes a junction box, desiccant, and a potting kit)
Cable assembly, 18.29 m (60 ft), connector on both ends
3 Completed assembly
Item no.
800014901
FDJCTBOXCBL-030
FD9000CBL-030
FDJCTBOXCBL-060
FD9000CBL-060
English 23