Tools Required; Installing; Installing The Wall Mount - Porsche 7PP.971.675.AA Manual Del Usuario

–
In order to ensure secure fastening, check the
condition of the wall before installation.
–
Install the Basic wall mount so that it is not near
pathways and the charging cables do not cross
any pathways.
– Install the Basic wall mount so that the distance
from the power plug to the power socket does
not exceed the available supply cable length.
– Install the electrical socket as close as possible
to the preferred parking position for the vehicle.
Take the orientation of the vehicle into account.
–
Make sure the distance of the electrical socket
from the floor and ceiling conforms to national
standards and regulations, to ensure comfortable
use.
g Refer to chapter "Safety instructions" on page 5.

Tools required

–
Spirit level
–
Power or hammer drill
–
Screwdriver

Installing

Installing the wall mount

Installing the Basic Wall Mount
Fig. 3 Drilling dimensions
1. Mark the drill holes on the wall.
2. Drill the mounting holes and insert wall plugs.
3. Press the basic wall mount (Fig. 3) into the
2
cable guide (Fig. 3) from the front.
1
4. Screw the basic wall mount to the wall.
Installing the plug holder
Fig. 4 Distance from wall mount to plug holder
When installing the plug holder, ensure a distance of
7.9 in. (200 mm) from the basic wall mount.
Installing
9