"B" with one having the same
•
characteristics.
Screw back on glass cover "A"
•
while observing washer "C".
•
Put the side grids back on ensuring
they are well fitted.
Should the glass lid be broken or damaged, do not use the oven until the lid is replaced
(Contact the Assistence Centre).
IV. EXTRAORDINARY MAINTENANCE
It is advisable to have the appliance subjected to periodical checks (at least once per year) by
a specialized authorized technician.
Any maintenance, installation or repair work must be carried out by qualified authorized
personnel by contacting the Assistance Centre. Before carrying out any operation the appliance
must be plugged out at the mains, turn off the water mains taps and wait for it to cool down.
Before moving the appliance from position, check that the electricity and water connections
(electric cables water pipe and drainage) are correctly plugged out.
If the appliance is on wheels check that electric cables, pipes or anything else are not damaged
while moving it. Ensure the break is on. Avoid placing the device near heat (such as fryers etc.).
After carrying out the task and replacing the appliance in its initial position, check that the
electric and water are connected correctly.
V.
MAINTENANCE IN CASE OF BREAKAGE
If the appliance breaks, disconnect it from the mains and turn off water.
Before ringing Customer Service, check the chart below.
FAILURE
The oven doesn't start
models with inverter gear)
The fan stops while the oven is on
(This only for models with inverter
gear)
Internal light does not work
There is no water inflow from the
humidifier pipes
Non-uniform cooking
E n g l i s h
CAUSE
The door is not closed but open
(This only for
Door Micro switch doesn't work
properly (for oven with inverter
system)
Safety thermostat measure motor
Motor capacitor break
Loose lamp
Blown lamp
Water inlet closed
Incorrect connection to the water
supply system
The water filters are blocked by
impurities at the top
The fans no long invert the
direction of rotation (only model
with inverter system)
One of the fans not operating
| 11
SOLUTION
Check that the door is closed
Contact specialised technician for repair
(Assistance Service ).
Turn off the oven and wait for the motor's
thermal protection to reset itself.
problem persists call a specialised repair
technician (Assistance Service).
Contact specialised technician for repair
(Assistance Service ).
Correctly fit the lamp into the lamp holder
Replace
maintenance )
Open water inlet
Check connection to the water supply
system
Clean the filters
Contact specialised technician for repair
(Assistance Service ).
Contact specialised technician for repair
(Assistance Service ).
If the
the
lamp
(see
ordinary