Instructions For Maintenance; Maintenance - General Rules; Routine Maintenance - IPC CT105 Manual De Instrucciones

► connect the battery-charger connector to the battery wiring connector (fig 17, ref. 1);
► recharge following the instructions written in the manual to the battery-charger;
► at the end of the recharging time disconnect the connectors.

INSTRUCTIONS FOR MAINTENANCE

All maintenance operations on the electric system and those not explicitly described in this
manual must only be performed by trained technical staff in compliance with the safety re-
gulations in force and recommendations stated in the maintenance manual.
Maintenance – General rules
A regular maintenance performed according to the Manufacturer's intructions guarantees a better
performance and endurance of the machine.

Routine maintenance

Precautions
When cleaning the machine always observe the following instructions:
► avoid using water cleaners, which could let water go inside the electric or the motor com-
partments with a consequent damage or hazard of short circuits;
► do not use steam in order not to warp the plastic parts;
► do not use solvents or hydrocarbons, which could damage the hoods or the rubber parts.
Suction air filter and floating rod: cleaning
► stop the machine, turn the main switch (fig. 8, ref. 13) to the "0" position (off) to disable all
the machine's functions;
► open the dirty water tank lid (fig. 18, ref. 1);
► make sure that the recovery tank (fig. 18, ref. 4) is empty;
► take out the air filter (fig. 18, ref. 2) of the suction unit from the float support (fig. 18, ref. 3),
which is located on the upper inner side of the recovery tank;
► clean the filter with current water or with the detergent used in the machine;
► put the filter back in the support only after having it dried well;
► make sure that the filter has been replaced in its seat correctly;
► check that the floating rod (fig. 18, ref. 5), which is also fixed to the support (fig. 18, ref. 3),
moves freely and clean it, if necessary;
► close the dirty water tank lid (fig. 18, ref. 1);
Squeegee blades: check and replacement
The blades of the squeegee are used to scrub from the floor the film of water and detergent thus
allowing a perfect drying. As long as time goes by the continuous scraping rounds off and splits the
sharp edge in contact with the floor, thus reducing the drying efficacy and therefore requiring the
replacement of the blades. Therefore, often check their state of wear and tear.
Exchanging or replacing the blades:
► stop the machine, turn the main switch (fig. 8, ref. 13) to the "0" position (off) to disable all
the machine's functions;
► lower the squeegee by using the proper lever (fig. 8, ref. 11);
► take off the squeegee (fig. 2, ref. 8) from its supporting plate (fig. 9, ref. 2) by unscrewing
completely the two knobs (fig. 9, ref. 3);
INFORMATION
Do not use water on the motors or electric parts.
DANGER
GB
27