Cleaning The Housing; Cleaning The Tank - DeWalt DCV584L Traducido De Las Instrucciones Originales

EnGLIsh
Shut-off Feature
If by mistake the appliance is used without the dust filter in
place, a shut-off feature will be actuated when the liquid level
in the tank has reached its maximum. A float valve will block the
suction opening, after which the suction stops and the motor
speed increases.
Blowing (Fig. A)

WARNING: Never blow hazardous dust!
1. Empty and clean the tank 3
2. Connect the hose 9 to the blow outlet
3. Select the appropriate accessory.
To Empty the Tank (Fig. F)
The tank must be emptied when suction power
reduces significantly.
1. Release the latches 6 and remove the power head
the tank 3 .
2. Empty the contents of the tank into a waste container in
accordance with any current regulation for the disposal of
such waste.
3. Clean the filter 16 as described below in Cleaning.
4. Re-install the power head onto the tank and secure
the latches.
Cleaning (Fig. F, G)

WARNING : To reduce the risk of serious personal
injury, turn appliance off and disconnect appliance
from power source and remove battery pack before
cleaning, making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

Cleaning the Housing

Regularly clean the housing with a soft cloth.

Cleaning the Tank

The tank should be cleaned after each use or when switching
substances during use.
1. Empty the tank 3 .
2. Clean the tank using mild soap and a damp cloth.
3. Dry the tank carefully using a soft cloth.
Cleaning the Wet/Dry Filter (Fig. G)
The wet/dry filter should be cleaned after each use.
If the filter is damaged or fails to operate properly, it must
be replaced.
1. Remove the wet/dry filter 16
and taking it off the suction opening
2. Shake off excess dust by tapping the filter into a
waste container.
3. Depending on its condition, rinse the outside of the filter
under lukewarm running water.
4. Secure the filter again by placing it over the suction opening
and turning it clockwise.
34
before use in blowing.
5 .
2 from
by turning it counterclockwise
17 .

WARNING :
• Do not wash the inside of the filter.
• Let the filter dry thoroughly if the inside becomes wet.
• Do not use a brush to clean the filter.
• Never use compressed air or a brush to clean filters,
otherwise damage to the filter membrane will occur
which will allow dust to pass through the filter.
Cleaning the Suction Opening Filter
(Fig. G)
The suction opening filter needs to be cleaned if the appliance is
operated without the dust filter in place.
1. Keeping the float valve 18
from the suction opening
2. Rinse the filter under lukewarm running water.
3. Dry the filter before putting it back in place.
4. Clean the float valve 18 using a damp cloth.
Troubleshooting
If your vacuum seems not to operate properly, follow the
instructions below. If this does not resolve the problem, please
contact your repair agent.
Problem
Motor does not run
Suction capacity decreases
out of the way, remove the filter
17 .
Solution
Check power cord, plugs and
outlet, or battery contact,
charging condition of battery
Ensure the on/off/tool
control switch is in the ON
position I.
Remove blockages in the
suction nozzle, suction tube,
suction hose, float valve
or filters.
Check for proper installation
of the filters.
Clean or replace the filters.
Empty canister, refer to
Empty Tank under Operation.