Opening/Closing The Door; Settings To Be Carried Out Before The Initial Start-Up; Loading The Pellets - Cadel AQUOS15 Manual De Instrucciones

It is extremely important to make sure the boiler is not immediately overheated and the temperature is
increased gradually, initially using low power.
This will prevent damaging the ceramic or serpentine tiles, the welds and the steel structure.
EN
8.2

OPENING/CLOSING THE DOOR

8.3

SETTINGS TO BE CARRIED OUT BEFORE THE INITIAL START-UP

Once the power cable is connected in the rear part of the stove, turn the switch, also placed at the rear,
to position (I). To switch the stove on or off press key 1 on the control panel.
8.4

LOADING THE PELLETS

Fuel is loaded from the upper part of the stove by opening the door. Pour the pellets into the hopper.
To ease the procedure carry out the operation in two steps:
Pour half of the contents into the hopper and wait for the fuel to settle on the bottom.
Then complete the operation by pouring in the rest.
68
DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!!
ATTENTION!
The door must be closed properly for the boiler to work correctly.
Use suitable protective clothing (such as gloves) to open the boiler door.
Never remove the protection grille from within the hopper. When loading prevent the
pellet bag from coming into contact with hot surfaces.
No other type of fuel other then pellets, in compliance with above-mentioned
specifications, is to be inserted into the hopper.
Store the back-up fuel at a suitable safety distance.
Do not pour the pellets directly onto the brazier but only into the hopper.
Most of the stove surfaces are very hot (door, handle, glass, smoke outlet pipes, hopper
door, etc.). It is therefore recommended to avoid coming into contact with these parts
without adequate protective clothing.
Fig. 19 - Key and display
AQUOS - IDRON